Analog
Tri-Axial 6 Degree-of-Freedom MEMS IMU Module
The Gyrocube 3A is a member of the Gyrocube series of
six degree-of-freedom IMU modules. These products have tri-axial MEMS
based angular rate and accelerometer sensors with analog outputs. The
Gyrocube3 is a complete 6DOF analog IMU solution in 1 cubic inch of volume.
An optional digitizer module is available for easier interface to digital
systems. On-board temperature sensor for compensation. Accelerometer
options for ±2g & ±10g's.
Angular rate gyro sensitivities of ±200
or ±400°/sec.
Standard systems are factory set for unity gain.
INERTIAL
ANGULAR RATE
Angular Rate Range: ±200°/sec (±400°/sec available)
Bandwidth: 40Hz
Start-up Time: <1 sec
ACCELERATION
Acceleration Range: ±2g
(±10g available)
Bandwidth: 60Hz
ELECTRICAL
Output: 0-5V (Center 2.5V (0°/sec / 0g nominal)
Interface Connector: JST - B12B-ZR
Mating Connector: JST - ZHR-12
Input Voltage: 5V (±2%)
Current: 27mA
Power: 135mW
PHYSICAL
Temp Range (OP): -
Temp Range (NOP): -
Vibration (NOP): -
Shock (NOP): -
Mass: 7g
Dimensions: 1.2" X 1.25" X 0.6"
SPECIFICATION SUBJECT
TO CHANGE WITHOUT NOTICE
OPTIONS
Gyrocbe 3A Development Kit
Includes: Interface Cable, DC Power Supply, Stand-offs and Screws
Cable with Power Supply Connector - P/N: 305-1235A PDF
Cable with Flying Leads - P/N: 305-1206A PDF
Bridge Cable (Digitizer Interface) - P/N: 305-1226A PDF
DC Power Supply (5V) - P/N: 310-0502B PDF
Digitizer/MX Module
with Serial Output - LINK
Serial/Power Cable for DigititzerMX - PDF
Stand-Off/Mounting Kit PDF
ORDERING INFORMATION
23503-200-0020-A - Gyro: ±200°/sec (40Hz) / Acceleration: ±2g /
( 60Hz)
23503-200-0100-A - Gyro: ±200°/sec (40Hz) / Acceleration: ±10g /
( 60Hz)
23503-400-0020-A - Gyro: ±400°/sec (40Hz) / Acceleration: ±2g /
( 60Hz)
23503-400-0100-A - Gyro: ±400°/sec (40Hz) / Acceleration: ±10g /
( 60Hz)
Increased sensitivity available. Please contact us for details.
CABLING DIAGRAM PDF
PAT. PEND.
